jD-IOBoard v1.1, Driver board for your needs
jD-IOBoard just got better. This is our new v1.1 board. So take a look at our document site to notice differences with older board.
If you need to drive LED strips, LEDs, Lamps, Relays or similar devices jD-IOBoard is the answer for your needs. This board is fully Arduino compatible board and it has 6 high power outputs and can handle all the way 42 Volts and 500mA / output pin.
Board have easy access to FTDI / UART and I2C ports. Among high power outputs there are several TTL level GPIO pins and Analog pins.
- Atmega 328P MCU
- ULN2003A darlington array for high power outputs
- 6 x TTL GPIO pins
- 6 x TTL Analog pins (only 4 if using I2C bus)
- FTDI connector
- ISP pins for deep programming
- Size: 37mm x 18mm